MP79S – LandCruiser Inner Guard Protection

About Product

The MP79S Inner Guard Protection is a 4 mm white HDPE guard liner moulded to fit the Toyota LandCruiser 79 Series single cab and dual cab, for vehicles working in mining, exploration and off-road environments.

Fitted as a protective barrier over the vehicle's inner guard area, the MP79S takes the punishment that would otherwise land on the panel itself — gravel strike, abrasion, mud packing and the corrosive wear that comes from prolonged exposure to harsh mine-site conditions.

Mine-site ground material carries varying minerals, salts and chemical compounds that accelerate erosion and corrosion of exposed vehicle components. HDPE is chemically inert, non-corroding and highly abrasion resistant, so it absorbs that exposure without breaking down the way painted steel does. The white finish also reflects available light into the guard cavity, which makes a noticeable difference when inspecting or servicing a vehicle underground.

The MP79S is supplied in left and right sets, with two halves per side. Each half is moulded to the contour of the inner guard and locates on the vehicle's existing bolt holes, so fitment requires no drilling, cutting or modification to the body. Because the liner follows the panel closely, there is no cavity for mud and debris to pack in behind it. At 4 mm the panels are light enough to handle and fit single-handed in tight underground workshop conditions, and a single damaged half can be replaced rather than the complete liner.

Key Features

• Manufactured from 4 mm white HDPE — a tough, impact-resistant polymer that flexes rather than dents and will not rust
• Lightweight construction adds minimal weight to the vehicle and is easily handled by one person during fitment
• White finish reflects light and brightens the guard cavity, improving visibility for underground inspection and maintenance
• Moulded to the contour of the 79 Series single cab and dual cab inner guard for a close, gap-free fit
• Close-fitting profile prevents mud and debris packing in behind the liner
• Supplied as left and right sets, two halves per side, for easier handling and fitment in confined areas
• Mounts to the vehicle's original guard bolt holes — no drilling or modification to the body required
• Two-piece design allows individual halves to be removed or replaced without pulling the complete guard liner
• Shields the inner guard from gravel, mud, debris and abrasive ground material
• Reduces direct contact with minerals, salts and chemical compounds present in mine-site soils and water
• Helps minimise corrosion-related deterioration and premature wear of body and guard components
• Suitable for demanding mining, exploration and off-road environments